Statim 2000 user manual

Next Page. Toute autre marque de commerce are the property of their respective owners. Page 3 1. The Statim is a compact, counter-top unit that features a number of sterilizing cycles designed to meet your needs and suitability for steam sterilization.

Page 4: Important Information Do not permit any person other than certified personnel to supply parts for, service or maintain your Statim. SciCan shall not be liable for incidental, special or consequential damages caused by any maintenance or services performed on the Statim by a third party, or for the use of equipment or parts manufactured by a third party, including lost profits, any commercial loss, economic loss, or loss arising from personal injury.

Plastics cycle button. When you receive your Statim packing carton, the items listed below will be included. If any of the items are missing, contact your dealer immediately so the situation can be corrected. Page 6 2. Figure 2 level indicator keypad reservoir cap power indicator active indicator power switch power cable port leveler feet exhaust tube port biological filter optional printer The following symbols indicate: A potential hazard Heavy Duty Unwrapped STOP button.

Page 7: Installation 3. Installation 3. Please review these factors, and select a suitable location in which to install the unit. The impurities and additives in other water sources will cause an error reading on the LCD. If you have a water conductivity meter available from SciCan, order number S check each new water container before filling the reservoir. T urn the power switch at the back of the unit OFF. For the Statim press and hold the Wrapped Cycle button.

For the Statim press and hold the Unwrapped Cycle button. Page 10 Once the unit is installed and before any instruments are sterilized, run two Wrapped Cycles see Sections 4. Remove the cassette once it has cooled. Clean the top lid and bottom tray sections using a soft cloth to wipe the inside surfaces and then rinse thoroughly with tap water.

Page Instructions For Use 15 mm to 20 mm " to " gap between the front of the Statim and the cassette handle. Page Statim — Using The Cassette 4. Page Statim — Stat-Dri Plates Up to ten plates can be arranged either along the length of the rack or across the rack. With the exception of the U. Additional plates may be ordered from SciCan SciCan part number Page 14 The use of cloth wraps in the Statim is not recommended.

The use of cloth wraps in the Statim is not recommended. This system consists of self contained biological indicators and incubators.

Page Instrument Mass Guide 4. If the results do not change, do not process any more instruments within the Statim and contact your SciCan dealer for further assistance. Because the turnaround time for the 3M Attest is up to 48 hours, it is recommended that the tests be conducted so that the incubation period occurs during a period of planned downtime such a the last cycle before a weekend.

Page Statim — Selecting A Cycle 3. See Section 4. Page 19 4. Air Dry Only Cycle This is not a sterilization cycle. The Air Dry Only Cycle starts automatically after each sterilizing cycle and runs for 60 minutes.

Air drying may be interrupted by pressing the STOP button. To ensure that the contents of the cassette are dry, the cycle should run for the full 60 minutes. Page Statim — Running A Cycle 4. See Section 6. Troubleshooting for more information. Page Statim — Selecting A Cycle 4. It is important not to overload the chamber as this can inhibit steam access to all instrument surfaces.

Page 23 4. Page 24 4. To operate each cycle, follow these steps and watch the LCD. Page 26 4. Page Stopping A Cycle 4. If the stop button is pushed, the cassette is removed, or the unit detects a problem while operating the cycle will stop and the amber active light will flash. Page Cleaning The Cassette Keeping the Statim cassette clean is good clinical practice and assists in the function of the unit. SciCan recommends that the interior surface be cleaned at least once a week.

Use dishwashing soap or a mild detergent that does not contain chlorine. Page 29 To ensure optimum performance of your Statim cassette autoclave, change the cassette seal every cycles or every six months, whichever comes first.

Certified Pre-owned Statim 3 month warranty with cassette and bottle kit A cassette that has passed temperature testing is included. A new bottle kit and power cord are included.

We have all of the proper tools to refurbish the right way. Here is what we do to refurbish our autoclaves. Wo rk in g. Item Number : G4. Fort Myers, FL No job is too large or small. Statim G4 size Cassette size. Estimated cycle range is over 20, Statim 'Low Cycles'. Simply select one of the three sterilization programs and with a single touch of the keypad, begin the cycle.

Autoclave Scican Statim Parts front cover with touch pad and display Front cover with touch pad and display. The cassette is in very good condition and has a relatively new seal. Refurbished Scican Statim Autoclave Simply select one of the three sterilization programs and with a single touch of the keypad, begin the cycle. Make: SciCan. Model: Statim Type: Steam Autoclave, Class S. Autoclave Cleaner.

What does DSI do to refurbish an Autoclave?. Statim cassette wire mesh instrument rack. Rack only Cassette not included. Rack only Cassette not included..